I found it best to use both hands.

2) The sprayer is hard to use on the ceiling since the little intake straw is meant to use in a normal vertical orientation.

Stabilize the Wall’s Edge.

How to Repair Plaster Walls. .

Step three: Inject the Plaster Magic Adhesive into the conditioned holes.

The looser the plaster is the more you will use.

There is some settling during shipping as these are packaged by weight not by volume. , being careful to go only through the plaster and not into the lathe. The Plaster Magic® conditioner is used prep the plaster and lath prior to injection of Plaster Magic® adhesive and to consolidate areas.

<strong>Plaster repair consists of two distinct tasks, stabilization and cosmetics.

with sprayer: Individual bottles of Big Wally's Plaster Magic® Conditioner are for previous Plaster Magic® customers that need additional material to finish a project. . I used for first time in 2017, and the work turned out very nice.

Tools & Home Improvement. class=" fc-smoke">Nov 8, 2018 · Product Description.

1.

This time-tested repair method restores the plaster wall to good-as-new condition.

. 1.

The fine print says some variation of: Ensure surfaces to be bonded are clean, dry, structurally sound and free of frost, dust, grease, oil, and other foreign contaminants. Using the putty knife, apply a thin coat of joint compound to the crack.

The Plaster Magic® conditioner is used prep the plaster and lath prior to injection of Plaster Magic® adhesive and to consolidate areas down to the lath in need of patching.
First, holes are drilled on either side of the crack and dust vacuumed out.
Conditioner: 16 oz with sprayer.

If I didn’t have photos to show, no one would believe me.

Allow to dry 24 to 48 hours.

com/HowToFixPlasterWall. . Technical Details.

The Plaster Magic Painters Pack repairs approximately, 18 linear feet of plaster cracks or 60 square feet of loose plaster. First, holes are drilled on either side of the crack and dust vacuumed out. Step one: Drill holes to access space between the plaster and lath. If I didn’t have photos to show, no one would believe me. . Look for compound, paint flakes, and other debris in the crack and scrape it out.

.

Remove screws and washers after a minimum of 24 hours. .

.

Drill until the bit hits the lath.

How does plaster magic work?Plaster Magic stabilizes weakened plaster by reattaching it to the lath using a two-part system: conditioner and adhesive.

I am going to reattach the cracked/loose plaster to the lath with Powergrab using the method outlined here: http://starcraftcustombuilders.

It works great, but it is crazy expensive for what you get.